"Cannot Proceed" message when switching? at DVinfo.net

Jon Braeley · August 7th, 2008, 02:50 PM

When I am in white balance A, I get a "cannot proceed" message if I switch to the preset or even memory B. It stays in A.
I checked I am not in full auto etc. Not that it should make a difference.
I am using the EX-3. It's been a while since I had my Ex-1, so I am getting back up to speed. I cannot recollect this happening in the Ex-1, so I cannot see a fix in the menus.

Tom Roper · August 7th, 2008, 03:30 PM

On the EX1 that happens because the menu parameter is on "full" instead of "partial."

Serena Steuart · August 7th, 2008, 06:54 PM

Must remember that while "cannot proceed" reads like an indication of a fault, it just means that the particular option has been over-ruled by your menu setup.

August 7th, 2008, 02:50 PM	#1
Jon Braeley Major Player Join Date: Oct 2007 Location: Miami, FL Posts: 528	"Cannot Proceed" message when switching? When I am in white balance A, I get a "cannot proceed" message if I switch to the preset or even memory B. It stays in A. I checked I am not in full auto etc. Not that it should make a difference. I am using the EX-3. It's been a while since I had my Ex-1, so I am getting back up to speed. I cannot recollect this happening in the Ex-1, so I cannot see a fix in the menus.

August 7th, 2008, 03:30 PM	#2
Tom Roper Trustee Join Date: Jun 2004 Location: Denver, Colorado Posts: 1,891	On the EX1 that happens because the menu parameter is on "full" instead of "partial."

August 7th, 2008, 06:54 PM	#3
Serena Steuart Major Player Join Date: Jun 2006 Location: Studio Alnitak, Melbourne, Victoria, Australia Posts: 640 Images: 3	Must remember that while "cannot proceed" reads like an indication of a fault, it just means that the particular option has been over-ruled by your menu setup.