Slight change needed to individual clip after multiclip

[Andy Paul]

Hi Everyone

Hope all is well with you all. I have a question for the multiclip now it alls out there. I have 5 cameras that I have used for a concert and have grabbed the footage for a multicam session.

After setting the in points with the only thing I have to sync up with (usually a sound like an applause) I check out the sync of all the 5 clips. Sometimes one or two might be out by about 5 frames or so. Is there anyway I can trim the clip a few frames left or right so it matches up with the other frames from within the multiclip window showing all the clips. Currently, I have to go back to the offening frame in the browser, change the in point of the offending clip and then re make the multiclip. This seems a bit of a long winded way to do it, is changing clips from within multiclip window possible

Thanks

Andy

[Andy Paul]

If any one is interested, I came across the answer whilst surfing the net.

To make a slight change to an individual clip in a multicam set up

click on file to select
press and hold - ctrl and shift
move the mouse over the footage you want to change
click and move left or right to move footage start and end point

[Winfried Dobbe]

Thanks, didn't know that either. I'll give it a try.