BNC to TRS for timecode at DVinfo.net

Nathan Lawrence · April 20th, 2010, 12:02 AM

I'm trying to send timecode from my EX3 - which has BNC timecode outputs - to my Metric Halo ULN-8, which has 1/4" TRS (balanced) SMPTE Input. Any suggestions on how to wire up cable/connectors to do this?

Thanks.

--Nathan Lawrence

Rick Reineke · April 20th, 2010, 11:15 AM

I haven't used a Metric Halo ULN-8 but typically, BNC/Coax to TRS (or line level XLR)
Center conductor 'Hot'> Tip (XLR pin-2)
Shield> Ring (XLR pin-3) (or tie Ring to Sleeve, XLR= tie pin-1 & 3 together)
Shield> Sleeve/ground (XLR pin-1)

However a few manufacturers' recommend floating the Ring / XLR pin-3 on their products when inputting an un-balanced signal.

April 20th, 2010, 12:02 AM	#1
Nathan Lawrence Regular Crew Join Date: Feb 2008 Location: Cobleskill, NY Posts: 51	BNC to TRS for timecode I'm trying to send timecode from my EX3 - which has BNC timecode outputs - to my Metric Halo ULN-8, which has 1/4" TRS (balanced) SMPTE Input. Any suggestions on how to wire up cable/connectors to do this? Thanks. --Nathan Lawrence

April 20th, 2010, 11:15 AM	#2
Rick Reineke Inner Circle Join Date: Aug 2008 Location: New York Posts: 2,039	I haven't used a Metric Halo ULN-8 but typically, BNC/Coax to TRS (or line level XLR) Center conductor 'Hot'> Tip (XLR pin-2) Shield> Ring (XLR pin-3) (or tie Ring to Sleeve, XLR= tie pin-1 & 3 together) Shield> Sleeve/ground (XLR pin-1) However a few manufacturers' recommend floating the Ring / XLR pin-3 on their products when inputting an un-balanced signal.