|
|
|
|
|
|
|||||||||
 |
|
|
Thread Tools | Search this Thread |
July 28th, 2003, 09:25 PM
|
#1 |
|
Regular Crew
Join Date: Feb 2003
Location: Athens, GA
Posts: 45
|
hiss on XL1S but not XL1
I'm currently editing a piece that I shot with 2 cameras. One was an XL1S and the other was an XL1. They both were recording at the same time.
However, the XL1S has a loud tape hiss where the old XL1 has little to no tape hiss. The room I was recording in was very quiet besides the people speaking. Has anyone else noticed the XL1S has a louder tape hiss? I was using the on board mics. Is there anything I could possibly do to equal the two systems out. I'm going to have to use all the audio from the XL1, which isn't a prob. But in the future, it might be a problem. As always, any suggestions or comments would be helpful. Thanks Annie Cheatham |
|
|
|
July 30th, 2003, 03:29 PM
|
#2 |
|
RED Code Chef
Join Date: Oct 2001
Location: Holland
Posts: 12,514
|
Are you sure you used the exact same audio settings. If one was
on auto gain or used a manual setting higher/lower then the other that might explain the difference as well.
__________________
Rob Lohman, visuar@iname.com DV Info Wrangler & RED Code Chef Join the DV Challenge | Lady X Search DVinfo.net for quick answers | Buy from the best: DVinfo.net sponsors |
|
|
|
|
July 30th, 2003, 06:50 PM
|
#3 |
|
Regular Crew
Join Date: Feb 2003
Location: Athens, GA
Posts: 45
|
no, the settings were the same. if it persists, i'll just take it in for service. but it is a new camera....
thanks annie c |
|
|
|
|
| ||||||
|
||||||
|
|
