Battle Vaughan |
March 31st, 2009 02:28 PM |
If your right angle connector is made by Neutrik, it is made to orient in iirc three different positions; you have to partially disassemble it (remove the two screws, and re-position the inside part, the insides fit into grooves in the shell) . AFAIK this might be possible with other brands as well..../Battle Vaughan/miamiherald.com video team
update, just went to check ... after you take the shell apart, just push up slightly on the inside part and rotate it until it clicks into one of the other positions, no need to remove the inside from the outside. On the one I have in my hand, there are 5, not 3, possible positions.../bv
|