Where is the absolute most factory restore/rest
located in the 350 & 330 XDCAMs?

Operations Menu then the Reset Page. You can then reset all settings to standard at the User level.

Also,
You can return all settings in the User Menu to the standard settings by displaying the user file page of the File menu, selecting User Preset, and then select yes to set all settings in the User menu to standard settings.

Bob, thank you for your reply.

My real problem is the I can't get my colors
to match from my 350 to match my 330s. When the
cameras are all reset the red levels are higher
on the 350 at default I am guessing.... All menu settings
appear the same from the reset 350 & 330s.

All cameras have the same lenses side by side white ballanced
and all reset, still have the problem...? Any suggestions?

How do you look at the footage? Maybe a Component/SDI difference?

The footage is looked at on Final Cut Pro with this problem.
The 330s have component out monitoring and the 350 has HD-SDI
monitor. All show the 350's native footage with more red in it than the 330's.

maybe different firmware?
maybe needs a reset in service menu?

The footage is looked at on Final Cut Pro with this problem.
The 330s have component out monitoring and the 350 has HD-SDI
monitor. All show the 350's native footage with more red in it than the 330's.

Okay, try this. Use FAM import from both the F330 and F350 to compare. That way, you're using the same method to capture, and the same codec for each camera. I'm thinking that the component vs. HDSDI methods of evaluation are somehow different. I don't have any solid proof, so that's why I suggested the FAM mode so that you eliminate as many variables as possible.

-gb-