View Full Version : Which wireless frequency, does it really matter?


David Bertinelli
October 24th, 2006, 12:12 PM
I'm looking at getting the Sennheiser Evolution G2 100 Lav system and noticed that this system comes in different frequencies. They are grouped in 518MHZ-554MHz or 626MHz-662MHz or 740MHz-776MHz; is there any advantage to one of these groupings?

I know red is postive and black is ground.
That is the extent of my electronics knowledge so any insight would be helpful.

Cheers,
D

Martin Pauly
October 24th, 2006, 01:14 PM
Have a look at this thread:
http://www.dvinfo.net/conf/showthread.php?t=73755

Or, search this forum for "wireless frequency", and you should find the information you are looking for.

Good luck!

- Martin

David Bertinelli
October 24th, 2006, 02:27 PM
Martin,

That's info I was looking for.

Thank You!


Do I have to go to the back of the classroom cause I didn't use the search function right away? ;)

Cheers,
D

Dan Keaton
October 24th, 2006, 03:30 PM
Dear David,



For audio, Red is for Positive, Black is for Ground.


In the United States:

For house wiring: Green is for Ground, White is Neutral, and Black is Hot!

I thought you might like to know, in case you ever work on house wiring.

I was amazed when I learned that Black was Hot after my long time experience with black being ground for audio!

Marty Wein
October 24th, 2006, 04:01 PM
Check out the Sennheiser Frequency Finder to determine the best frequency for your primary area

http://www.sennheiserusa.com/newsite/mat_dev/frequencyfinder/Freqfinder-ew.asp

There are three sets of blue, representing the three Frequency Groups A, B and C

Generally you would choose the group that has the most, free space

Example:
In BATON ROUGE, LOUISIANA you would chouse Group C as it is completely free. However A or B will also work since there are still plenty empty spots.

http://www.sennheiserusa.com/newsite/mat_dev/frequencyfinder/PDFs/LOUISIANAew.PDF

Greg Bellotte
October 24th, 2006, 05:05 PM
I live near Salt Lake and find PLENTY of usuable frequecies in both the A and B groups. I have several sets of mics in B, and two sets of IEM in A. They travel almost every week and reguardless of city I always manage to find plenty of open freqs in both groups.

Sorry, no experience with the C group.

Glenn Davidson
October 24th, 2006, 05:20 PM
I was on a rooftop in Hollywood and A and B were both locked up. i ended up using a CH with a weak signal. I have never seen that before!

Guy Cochran
October 25th, 2006, 10:58 AM
I was on a rooftop in Hollywood and A and B were both locked up. i ended up using a CH with a weak signal. I have never seen that before!
1440 Frequencies were locked up?
Did you perform an Auto Scan? If zero channels appearted free in 1 Bank, there are 7 more to Auto Scan. Just switch to Bank 2 then Auto Scan again.
There's also a quick video if you need to reference how to Auto Scan over at http://dvestore.com/dvgeartalk.html Click on "Sennheiser G2 Wireless Tutorial"

Hope this helps,

Glenn Davidson
October 28th, 2006, 12:32 AM
I was using a Shure system that operates from 692-716 and 782-808 Mhz. Each receiver only has 100 channels and no scan feature.