When using Scene Detect Capture mode with my JVC100HD as source device, and selecting to capture entire tape #1, it works fine, however when inserting tape #2 and Renaming Tape etc. it will roll the camera but not capture any media. When I give it an IN and Out point it will work fine. Anyone have an idea why this happens? Should I exit capture before inserting Tape #2, etc.?
Also when Setting Up for a new project, I have noticed that a Cineform Window pops up. Should I be attached to the internet for some capture up date or action to occure?

Thanks,

Gary

When using Scene Detect Capture mode with my JVC100HD as source device, and selecting to capture entire tape #1, it works fine, however when inserting tape #2 and Renaming Tape etc. it will roll the camera but not capture any media. When I give it an IN and Out point it will work fine. Anyone have an idea why this happens? Should I exit capture before inserting Tape #2, etc.? Gary

Yes, happens to me too with ppro1.51. Just close ppro after each cassette and reopen and it works again...


Also when Setting Up for a new project, I have noticed that a Cineform Window pops up. Should I be attached to the internet for some capture up date or action to occure?


No, just a splashscreen.

alex

Thanks Alex. It's Just amazing... I have no less than 5 PPro Manuals and not them or even the PPro web sight mentions this situation.
Gary