Juergen Hansen
September 19th, 2012, 03:49 AM
Hi,
we are starting the editing of a documentary project, using FCP7 and Stereo 3D Toolbox LE.
At the end I need an output in side by side on HDCAM SR - that is no problem.
But I would also need a seperate output for left and for right.
Here we don't quite understand the workflow.
Is it possible to output left and right by guarding the corrections done by Stereo 3D Toolbox for each eye?
In the Light Edition I don't find this feature - only in the Full Edition.
But I bought back in 2009 the very first Stereo 3D Toolbox, and there it is possible to output "Solo Left Eye 2D" and "Solo Right Eye 2D".
Hm. Should we work with this old version - which by the way was more expensive than the new Light Edition? The only disadvantage with the old version I see at the moment, there is not the Feature "identify left / identify right".
Thank you very much for your help.
Best regards,
Jürgen
we are starting the editing of a documentary project, using FCP7 and Stereo 3D Toolbox LE.
At the end I need an output in side by side on HDCAM SR - that is no problem.
But I would also need a seperate output for left and for right.
Here we don't quite understand the workflow.
Is it possible to output left and right by guarding the corrections done by Stereo 3D Toolbox for each eye?
In the Light Edition I don't find this feature - only in the Full Edition.
But I bought back in 2009 the very first Stereo 3D Toolbox, and there it is possible to output "Solo Left Eye 2D" and "Solo Right Eye 2D".
Hm. Should we work with this old version - which by the way was more expensive than the new Light Edition? The only disadvantage with the old version I see at the moment, there is not the Feature "identify left / identify right".
Thank you very much for your help.
Best regards,
Jürgen