I have a little issue with Edius and Title Motion and I thought maybe there is someone here who can help me.
Where I work, I use Premiere 3 and Edius 5. I want to optimize a little bit the editing process and it has went well with Premiere, but I'm pretty new to Edius, so that is why I need your help.
This image should help:
http://i49.tinypic.com/1zcn8uw.jpg
So my problem is:
The green clip is a lower-third graphic.
In the adjacent title, I created a Title Motion Pro clip.
The picture was taken the second I saved the title.
As you can see the title is smaller than the green clip.
I know it can be set to be longer, because it does so on one computer, but on these other two behaves as in the picture.

So this is my question: where do I set the predefined length of a new title either in Edius 5 or Premiere Pro?

you can just grab the right edge of the title in timeline and stretch it to match the duration of the graphic

or go to application settings and change the default duration, be sure you untick add between in and out
http://www.videoproductions.com.au/assets/images/edius-settings03.gif

you can just grab the right edge of the title in timeline and stretch it to match the duration of the graphic

or go to application settings and change the default duration, be sure you untick add between in and out
http://www.videoproductions.com.au/assets/images/edius-settings03.gif

Thank you so much! That did the trick, altough my menus are a little bit different and I had to search a little until I found it.
Altough it's little, now I can save seconds!

I suggest you update your EDIUS5 to 5.51 (free)