Hello all,

So I just acquired a steadicam pilot from work and am familiarizing myself with it. I successfully hooked up one of my studios xha1's to the pilot monitor without issue however when I try with my own xha1 I can't get any picture from the bnc, is there a hidden setting in the menu pertaining to the bnc output? I can't seem to find it if there is. I'm hoping my output isn't fried but that could be the case. I've had the camera for about three years now and I know the ins and outs of this camera pretty well however this is the first time I've ever tried to use the bnc connector.

Thanks!

Hi Jaron,

There is a switch right next to the composite out on the back your xha1. AV1 & AV2, switch it to AV2 for BNC out. Sadly you cannot use both the composite and bnc at the same time.

-Aaron

Nice! Thank you Aaron, can't believe I missed that...

Hello:
I don´t know if the BNC output signal of XHA1 is only Standard definition or support HD 1080i like component output.
Thank you.
Josué Manzano

I don´t know if the BNC output signal of XHA1 is only Standard definition or support HD 1080i like component output.

the BNC output is a composite signal only