Jeremy Gasowski
December 31st, 2009, 02:00 PM
This forum is such a great resource and I appreciate all the help on the following, since after many hours googling and searching threads in this forum, I have not been able to find an answer.
I recently began shooting to just my CF card and when transferring my clips to FCP I notice that all my recording times were off by 2-3 seconds. Not sure how this happened, but I am confident that it was not user error....
- I was shooting skiing, and athletes were jumping off mogul airs.
- I was recording their in run, their trick, their landing , and leaving plenty of post roll
- I was using the REC/Pause button to initiate recording ( see camera settings below )
So, when I looked at the clips in FCP, they ended as athletes were in mid air, or just about to land.
My camera settings are as follows...
- Sony Z7U
- Sandisk Extreme IV 16gb CF ( 45 mb/s )
- Camera set to " Synchronous " using the REC/PAUSE for start stop
- MCR1 set to " Synchronous " and using "Cam-link"
I am running FCP 6.0.6, on a Mac Pro, and transferred using the Sony FCP plugin.
One final note, when viewing clips from the CF on the Z7U, they are experiencing the same issue.... so I'm guessing the problem isn't FCP or my transferring.
Thanks for the help!
I recently began shooting to just my CF card and when transferring my clips to FCP I notice that all my recording times were off by 2-3 seconds. Not sure how this happened, but I am confident that it was not user error....
- I was shooting skiing, and athletes were jumping off mogul airs.
- I was recording their in run, their trick, their landing , and leaving plenty of post roll
- I was using the REC/Pause button to initiate recording ( see camera settings below )
So, when I looked at the clips in FCP, they ended as athletes were in mid air, or just about to land.
My camera settings are as follows...
- Sony Z7U
- Sandisk Extreme IV 16gb CF ( 45 mb/s )
- Camera set to " Synchronous " using the REC/PAUSE for start stop
- MCR1 set to " Synchronous " and using "Cam-link"
I am running FCP 6.0.6, on a Mac Pro, and transferred using the Sony FCP plugin.
One final note, when viewing clips from the CF on the Z7U, they are experiencing the same issue.... so I'm guessing the problem isn't FCP or my transferring.
Thanks for the help!