Has anybody experienced their SDI out spigot suddenly ceasing to work. I 've troubleshot this from several angles and it just seems to have stopped working. The same set-up from my 350 to the monitor works fine so I know it's not on that end of the set-up.

Thanks
Warren Gentry

Hopefully the BNC connector has not become "unhinged" from the circuit board inside the camera. I recall the BNC connectors are connected right to circuit boards inside the EX cameras which means they are prone to becoming disconnected due to the torquing from connectors over time.

Hope I am wrong. Probably covered under warranty if it doesn't look like abuse.

See pages 107 and 109 in the manual - ILink must be disabled in menu for SDI out to work.

Thanks Ronn, That was the problem