View Full Version : can not view p2clips in P2CM software


Rami Golan
August 8th, 2008, 10:19 AM
i have upgraded the firmware to version 4.0 on my FS-100 but now i cannot view my clips in the P2 Management Software (version 1.3)

I can see them but they have a little red cross at the top of the thumbnail, when i double click i get the message:

"IT IS NOT PLAYBACK - It was not play back because there was incompleteness in the clip."

Yes that is a cut-n-paste :)

However the clips do play back from the FS-100 back into the HVX200e cam and seem fine. I don't have Premiere to check the files, because i usually send them direct to the editor..

Any thoughts welcome..