View Full Version : How Do I Get My Clip Insert Icon To Work?


Hugh DiMauro
June 28th, 2008, 11:31 PM
The little "clip insert icon" in the bottom right of my source monitor keeps telling me that "the source clip is bigger than the insert point" and won't allow me to insert (and ripple everything down to the right) without changing the size of my clip. Why does it do this? It never has before. Help!

Thanks

Roger Averdahl
June 29th, 2008, 07:13 AM
Thats because you have one In Point and one Out Point on the Timeline that dont matches the length of the In Point and Out Point in the source.

Solution: Clear the In/Out Point on the Timeline

Hugh DiMauro
June 29th, 2008, 06:58 PM
Roger: I don't recall ever setting an in and out point on my timeline. Is this done in my program monitor with the little brackets? And if so, will that lock up all insert attempts for that timeline until the in and out points are cleared?

Roger Averdahl
June 30th, 2008, 02:30 AM
Is this done in my program monitor with the little brackets? And if so, will that lock up all insert attempts for that timeline until the in and out points are cleared?
Yes on both questions.

To clear the In/Out Points:
1. Select the Timeline or the Program panel
2. Press G on your keyboard

Hugh DiMauro
July 1st, 2008, 07:30 PM
You won't believe how I'd been marking in and out points prior to my discovery of the brackets in the program monitor. Believe me, it is embarrassing.

Roger Averdahl
July 2nd, 2008, 02:16 AM
You won't believe how I'd been marking in and out points prior to my discovery of the brackets in the program monitor. Believe me, it is embarrassing.
Hugh, i have done the very same thing several times as well so i know your feeling. :)

I am glad that i could help you! :)